User Manual Q&AAnswer
Apr 12, 2025 - 03:08 AM
To assemble the KENDALL HOWARD Performance 100 and 200 Series Lan Station, please follow the steps outlined in the instruction manual provided. Here is a summary of the assembly process:
Step 1: Remove all components from the crate and place the worksurface on a sturdy working area with the xxxx holes facing up. Install two cross bars using the provided 1/4-20 screws.
Step 2: Install the left leg and the back right leg using the provided 1 1/2" bolts. Rotate the table onto its surface.
Step 3: Attach two cross bars to the lower shelf using 1/4-20 screws. The 100 Series will have 1 lower shelf surface, while the 200 Series has 2.
Step 4: Attach the lower shelf assembly to the bottom of the workbench using 1 1/2" bolts.
Step 5: Install the four leg levelers to the bottom of the workbench. If you have purchased optional castors, install them instead of leg levelers. Rotate the workbench onto the levelers.
Step 6: Align the back panel with the pre-drilled mounting holes on the rear LAN station legs and loosely install the provided 2 1/2" bolts through the back panel. Make sure the channel nut teeth face towards the bolt head.
Step 7: Slide the upper shelf channels over the channel nuts and adjust the height. Fully tighten the bolts.
Step 8: Install the four upper shelf supports using 1 1/2" bolts and channel nuts. The larger holes on the shelf supports should face outward. Slide the shelf supports into the upper shelf channels.
Step 9: Install the upper shelves using 1/4-20 screws. Adjust the shelf assembly to the desired height.
Step 10: Install the provided end caps in the designated locations.
For more detailed instructions and illustrations, please refer to the KENDALL HOWARD Performance 100 and 200 Series Lan Station Instruction Manual. If you have any further questions or need assistance, you can contact KENDALL HOWARD support through phone, email, mail, or their website.
Add New Comment