User Manual Q&AAnswer
Apr 12, 2025 - 01:04 AM
To install the Ambiane HP111 Recessed Anolis LED Lighting, follow these steps:
1. Ensure that the unit is installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
2. The unit is designed for indoor use only. Do not install it near highly inflammable liquids or materials.
3. Make sure nothing rests on the unit and it is not installed near an open flame.
4. Avoid installing the unit in dirty, dusty, or badly ventilated locations.
5. The ceiling or structure intended for installation of the unit must safely hold at least 5 times the weight of the unit fastened on it.
6. Ensure sufficient air access to the housing of the unit and avoid heat or anti-noise insulation.
7. Prepare a circular opening in the lower ceiling for installation.
8. Fasten the control unit on the ceiling using the provided holes in the housing.
9. Remove the frame with reflector from the Ambiane HP111 housing by pushing and turning it counter-clockwise. The frame is fastened in the housing by four locks.
10. Install the terminal block on the supply cable and connect it to the PCB RB 3729 of the control unit.
11. Install the terminal block on the DMX cable and connect it to the PCB RB 3729 of the control unit.
12. Install the terminal block on the LED unit cable and connect it to the PCB RB 3729 of the control unit.
13. Install any additional terminal blocks on cables according to the requirements of your installation.
14. Set the DIP switch according to your operation mode. The DIP switch is accessible through the aperture in the cover of the control unit.
15. Insert the LED unit into the prepared hole in the lower ceiling and xxxx two adjusting screws to slide and support the levers against the surface.
16. Insert the frame with reflector into the Ambiane HP111 housing and push and turn it clockwise until it snaps into the locks.
17. Snap the ring louver to the frame with reflector (optional accessory).
18. Connect the power supply, DMX, and any other necessary connections according to your setup.
Please refer to the user manual for more detailed instructions and diagrams.
Add New Comment