How do I install the ENCELIUM DALI Sensor Coupler E Luminaire Integrated? (ENCELIUM Dali Sensor Coupler E Luminaire Integrated Instruction Manual)

Answer

manuals.plus

Apr 11, 2025 - 10:51 AM


To install the ENCELIUM DALI Sensor Coupler E Luminaire Integrated, follow these steps:

1. Secure the DALI Sensor Coupler E to the luminaire using screws (not included). Make sure to install it in dry, indoor locations only.
2. If you want to perform independent ceiling integration, you will need to install the ECO CI KIT (ordered separately). This kit provides strain relief housing for the DALI Sensor Coupler E. It is also recommended for protection from electrical contact.
3. Remove the cable guards from the ECO CI KIT bases and place them onto the DALI Sensor Coupler E. Push the center of the cable guard down and bend it to wrap around the cable.
4. Install the cable guards on the LINE IN, DALI, and THIRD-PARTY SENSOR cables, then connect the wires into the corresponding ports on the DALI Sensor Coupler E. Place the ECO CI KIT covers onto the DALI Sensor Coupler E and tighten the screws.
5. If you are integrating an external third-party motion detector with a floating contact electrical connection, follow the instructions provided in the manual.
6. If you are integrating an external third-party motion detector with a switched mains electrical connection, follow the instructions provided in the manual.

Please note that the maximum total wire length for DALI and third-party sensor interface is 300 meters (984 feet). Also, make sure to read and follow all safety precautions mentioned in the manual before using the product.