User Manual Q&AAnswer
Apr 11, 2025 - 10:34 AM
To set up the debugger for the REALTEK Ameba-ZII DEV Ameba Z2 IoT Board, you will need to follow the instructions provided in the user manual. Here is a step-by-step guide:
1. Connect the Serial Wire Debug (SWD) connector of the Ameba-ZII board to the J-Link debugger.
2. Connect the J-Link debugger to your PC.
3. Install the J-Link GDB server software. You can download it from the official website of SEGGER.
4. Open the installation location of the J-Link GDB server and run "JLinkGDBServer.exe" to check the connection.
5. Make sure the configuration is correct and click "OK".
6. Check if the information is shown properly.
7. If the J-Link GDB Server is unable to detect the device, try re-connecting the wires and re-open "JLinkGDBServer.exe".
Please note that for debugging the Ameba-ZII board, you will need a J-Link debugger with the latest hardware version. Also, make sure to refer to the user manual for any specific requirements or updates regarding the debugger setup.
Add New Comment