User Manual Q&AAnswer
Apr 11, 2025 - 09:38 AM
To install the OPT7 Redline F150 Connect Adapter, follow these steps:
1. Open up your tailgate first.
2. Locate the two bolts that lock the tail light and loosen them.
3. Slowly move the loose tail light until it is completely removed. Be careful not to break the plastic clips on the inside of the tail light.
4. Locate the OEM wiring harness and unplug it from the tail light assembly by lightly pressing the Release-Latch on the connector.
5. To identify the signal location represented by the Connector/Wiring, read the relevant wiring instructions carefully before starting any work.
6. Note that there are two types of appearance on the tail light connector, and the product is only compatible with TYPE "A". If your truck has TYPE "B", remove the excess plastic on the wire harness plug provided.
7. Grab the Redline Quick Connect Expansion Adapter Harness and plug it into the vehicle's OEM wiring harness. Plug the other end into the tail light connector.
8. Route the Redline Quick Connect Expansion Adapter Harness from the left tail light opening to the right tail light opening, then repeat the same steps for the other side.
9. Use zip ties to secure the flat 4PIN trailer connector and reverse wire in place along the inner bumper.
10. Finally, connect the available tailgate light bar to the 4PIN trailer connector and reverse wire for full functionality testing.
Please note that OPT7 Lighting is not liable for damages or personal injuries while installing this product. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, it is recommended to seek professional assistance. Modified installations or installation recommendations not specified by OPT7 Lighting will void the product warranty.
Add New Comment