User Manual Q&AAnswer
Apr 11, 2025 - 09:18 AM
To connect the SoClean Adapter to your ResMed Airsense 10, follow these steps:
1. Detach the Injection Fitting from the Injection Hose A. Keep the Injection Fitting for future use.
2. Remove the original lid from the reservoir base by fully opening the lid and pushing one side of the hinge tab outward to free the lid from the base.
3. Lift the gasket from the original lid and transfer it to the new SoClean lid.
4. Install the new lid with the black adapter tube to the reservoir base by inserting the left pin into the left notch. Pull the lid towards you and insert the right pin into the right notch.
5. If needed, refill your reservoir. Close the new lid and insert the reservoir into your PAP unit as you normally would.
6. Connect the Injection Hose A by pushing it onto the end of the port of the adapter lid. You are now ready to use the SoClean.
Note: When adding water to your humidifier reservoir, remove the Injection Hose A from the adapter lid and remove the reservoir from the PAP machine. Add water, reinsert the reservoir into the PAP machine, and then reconnect the Injection Hose A.
WARNING: The Injection Hose A must be attached to the SoClean adapter at all times when operating your PAP or the SoClean.
For detailed instructions and illustrations, please refer to the manual provided with the SoClean Adapter for ResMed Airsense 10.
Add New Comment