User Manual Q&AAnswer
Apr 11, 2025 - 08:39 AM
To adjust the output voltage of the EATON PSG60N24RP AC-DC DIN Rail Power Supply, follow these steps:
1. Ensure that the power supply is switched off and the area is known to be non-hazardous before making any adjustments.
2. Locate the DC voltage adjustment potentiometer on the power supply. It is usually labeled or marked as "DC V ADJ" or something similar.
3. Using a suitable screwdriver or tool, carefully rotate the potentiometer in the desired direction to increase or decrease the output voltage. Refer to the manual for the adjustment range of the voltage.
4. While adjusting the potentiometer, monitor the DC OK control LED (green) on the power supply. It indicates whether the output voltage is within the acceptable range. If the LED is off or flashing, it means the output voltage is outside the tolerance limits.
5. Make small adjustments and allow some time for the output voltage to stabilize before making further adjustments. This will help ensure accurate voltage settings.
6. Once the desired output voltage is achieved, secure the potentiometer in place if necessary, as some models may have a locking mechanism.
Note: It is important to exercise caution and only allow skilled or instructed persons to carry out these operations, as electric current can be dangerous. Always refer to the instruction leaflet provided with the power supply for specific guidance and safety precautions.
Add New Comment