How to install DINI ARGEO TWL Series Overhead Monorail Weighing Scales using provided mounting kit? (DINI ARGEO TWL Series Overhead Monorail Weighing Scales Instructions)

Answer

manuals.plus

Apr 11, 2025 - 06:13 AM

To install the DINI ARGEO 100X50RTK TWL Series Overhead Monorail Weighing Scales using the provided mounting kit, please follow these steps:

1. Start by identifying the M10 bar length required for your installation. This length needs to be specified when ordering the product.

2. Ensure that you have IPE80 or IPE100 beams available for mounting the scales. If you require mounting on bigger beams, you can request it.

3. Gather the components from the mounting kit, which include:

- 4x xxxx ISO 4014 M10x80 Stainless steel

- 3x Washer UNI 6592 10.5x21 Stainless steel

- 2x Hexagonal nut M10x1.5 Stainless steel

- 1x Angle bracket 100x50 TWG - TWL - TW - TWS (4 pieces required)

4. Begin by attaching the angle brackets to the scales. You will need 4 angle brackets in total.

5. Position the scales on the IPE80 or IPE100 beams at the desired location for installation.

6. Use the screws, washers, and nuts to secure the scales to the beams. Insert the screws through the holes in the angle brackets and tighten them using the provided nuts. Make sure the scales are securely fastened to the beams.

7. Repeat the process for all 4 corners of the scales, ensuring that each angle bracket is properly attached and tightened.

8. Once all the screws are tightened, double-check the stability and alignment of the scales. Ensure that they are level and securely mounted.

9. After installation, refer to the product manual for calibration and setup instructions to ensure accurate weighing measurements.

Please note that the above instructions are a general guideline. It is always recommended to refer to the specific product manual provided by DINI ARGEO for detailed and accurate installation instructions.