User Manual Q&AAnswer
Apr 10, 2025 - 11:49 AM
To connect the Anolis ArcPower 192 Outdoor PSU to the power source and DMX controller, follow these steps:
1. Make sure the available voltage is not higher than stated on the rear panel of the fixture.
2. Connect the power/data cable to a junction box. The power/data cable has 3 cores for power supply and 2 shielded cores for DMX connection.
3. Connect the junction box to the mains power according to the provided tables in the manual.
4. Remove the end caps from the cable glands on the junction box and pass the cables into the box. Use the appropriate cable gland for the diameter of your cables.
5. Fully tighten the cable gland nuts and ensure that the cables are properly fastened.
6. Connect the LED modules to the ArcPower 192 Outdoor PSU using the Chogori connectors. Follow the order of cable connections specified in the manual to ensure correct operation.
7. For DMX control, use either the Robe Universal Interface or RDM Communicator. Connect the interface to the DMX data link as shown in the manual.
8. Set the DMX address and other settings using the control interface. Refer to the manual for detailed instructions on setting DMX address, selecting DMX mode, and other control functions.
Please note that these are general instructions. For specific details and illustrations, refer to the Anolis ArcPower 192 Outdoor PSU User Manual.
Add New Comment