User Manual Q&AAnswer
Apr 10, 2025 - 07:50 AM
To turn on and use the ADA Instruments Cube 360 Green Line Laser, please follow these steps:
1. Before use, remove the battery compartment cover and insert three batteries into the battery compartment with proper polarity. Then, put the cover back on.
2. Set the compensator locking grip (switch) into the ON position. This means the power is on and the compensator is working. If the switch is in an intermediate position, it means the power is on, but the compensation is still locked. If the switch is OFF, the line laser is off, and the compensator is also locked.
3. Press button (1) to switch on the vertical laser beam. Press it again to switch on the horizontal beam. Press it once more to switch on both the horizontal and vertical beams. Only switch on the necessary laser lines to save battery life.
4. Press button (2) to activate the "outside" mode. Press it again to switch to the "inside" mode. Use the detector of the laser beam for the inside mode. Refer to the operating manual for instructions on using the detector.
Please note that for specific tasks such as checking accuracy or checking plumb, there are detailed instructions provided in the manual. Make sure to follow those instructions for accurate results.
It is important to read the safety instructions and follow them carefully to ensure safe usage of the line laser. Regularly check the instrument for accuracy and general performance, and perform periodic maintenance as recommended.
For further assistance with warranty service and technical support, please contact the seller of the product or ADA International Group Ltd., the manufacturer, at the provided contact information.
Please refer to the complete user manual for more detailed instructions and safety guidelines.
Add New Comment