User Manual Q&AAnswer
Apr 10, 2025 - 07:38 AM
To install the PERUN AB++ On-Wire Mosfet, please follow these steps:
1. Remove the previous wiring from your airsoft replica.
2. Cut the motor wires (thicker ones, red and black) to the needed length and solder motor connectors to them.
3. Put heat shrink tubes on the connectors and shrink them using hot air or by cautiously placing them some distance over an open fire.
4. Cut the signal wires (thinner, red ones) to the needed length and solder them (in any order) to the trigger contacts and to the positive motor wire (red). Isolate this connection with a heat shrink tube.
5. It is recommended not to solder on the unit itself unless absolutely necessary.
Please note that the installation of the PERUN AB++ On-Wire Mosfet should only be done by experienced technicians. Improper installation may cause damage to your replica or the electronics, and Perun is not liable for any damages caused by improper installation.
For more detailed information and visual instructions, please refer to the user manual provided with the product.
Add New Comment