User Manual Q&AAnswer
Apr 10, 2025 - 05:32 AM
To adjust the tension of the timing belts on the XTool D1 Laser Engraver, please follow these steps:
1. Locate the screws that are used to set the tension of the timing belts. These screws are typically found on the right and left plates of the machine.
2. Using a screwdriver, turn the screws to loosen them slightly. Do not fully tighten the screws, as this may damage the timing belts.
3. If you are unable to put the optical shaft through the timing belt, it may be because the timing belt is set too tight. In this case, you can adjust its tension by turning the xxxx .
4. Slide the two sliders down against the front plate of the machine.
5. Fully tighten the two screws to secure the sliders in place.
By following these steps, you should be able to adjust the tension of the timing belts on the XTool D1 Laser Engraver.
Add New Comment