User Manual Q&AAnswer
Apr 10, 2025 - 05:17 AM
To install the LIVING basics Single Handle Pressure Balance Bath Faucet, follow these steps:
1. Start by referring to the installation reference size and make sure the main body is fixed at a width of 40mm. Knock two setscrews into the provided holes (part 4).
2. Connect the pipes into the valve body (part 5). Place the valve body in the hole and secure it with the xxxx (part 7). Then, connect the water supply hoses.
3. Plug the water outlets after the valve body is installed.
4. Remove the black cover plate (part 6). Install the handle (part 9) and diverter (part 13). Provide water from the water inlet and test for any leaks in the water pipes.
5. Test the system for 3 minutes at 1.6 Mpa when the ceramic cartridge is closed. Then, test for 3 minutes at 0.4 Mpa when the ceramic cartridge is open. Proceed to the next step if there are no leaks after testing.
6. Remove the handle (part 9) and diverter (part 13), and then put on the cover plate (part 6) after the water test is successful.
7. Backfill the wall with concrete and tile over the concrete. Remove the black cover plate (part 6) when it is available.
8. Feed the valve body with the panel (part 8), handle (part 9), and diverter (part 13). Use the Allen key (part 12) and screws (parts 10 and 14) to secure the handle (part 9) and diverter (part 13). Finally, put on the red/blue button (parts 11 and 15).
9. Take off the hand shower, up and down plugs, and turn on the cartridge to wash out any dirt in the water tube.
10. Use tape to install the shower arm (part 1) and elbow (part 16). Then, install the shower head (part 3) with the gasket (part 2).
11. Connect the flexible hose (part 19), gasket (part 18), and hand shower (part 17). Test for any leakage after installation is complete.
By following these steps, you should be able to successfully install the LIVING basics Single Handle Pressure Balance Bath Faucet.
Add New Comment