User Manual Q&AAnswer
Apr 10, 2025 - 04:56 AM
To attach the Agknx HEX Drive Auger to a tractor or skid steer powerhead, follow these steps:
1. Lower the tractor or skid steer gearbox/powerhead so that the bottom of the drive shaft is slightly higher from the ground than the auger standing up. Stand up the auger and align the flats of the hex drive of the auger with the powerhead. Align the pin through the hole of the auger and powerhead. Alternatively, you can lower the powerhead of the skid steer and lay it flat. With the auger lowered, align the flats and pin through the hole of the auger and powerhead.
2. Slide the auger onto the powerhead drive shaft and fix it with an auger pin and lynch pin. You can use a 3/4 inch or 7/8 inch auger attachment pin.
3. Raise the auger vertically and transport it to the operating location.
For more detailed instructions and safety information, please refer to the Agknx HEX Drive Augers User Manual.
Add New Comment