How do I install the WM Systems M2M Easy 2S Security Communicator? (WM Systems M2M Easy 2S Security Communicator Installation Guide)

Answer

manuals.plus

Apr 10, 2025 - 03:17 AM

Here is a step-by-step guide on how to install the WM Systems M2M Easy 2S Security Communicator:

Step 1: Place the SIM card into the SIM tray with the chip side facing down and the cut edge facing the PCB side.

Step 2: Push the SIM card until it is securely fixed.

Step 3: Wire and connect the input line(s) for sensors or sabotage detection. Use the IN1 and IN2 connectors. Choose the operation mode of the input line by selecting the jumper position. You can choose between contact input mode or voltage input mode.

Step 4: If you want to connect an alarm center, connect the TIP RING of the alarm center to the ALR port.

Step 5: Connect the antenna to the SMA connector.

Step 6: Connect the RJ11-RS232 cable's RJ11 side to the PROG port. Connect the other side of the cable (RS232 connector) to an RS232-USB adapter cable to connect to your PC. Use the EasyTerm application to configure the device.

Step 7: Download the EasyTerm software from the provided link and install it on your PC.

Step 8: Download the latest device firmware for software refresh from the provided link.

Step 9: Extract the EasyTerm ZIP file and run the EasyTerm_v1_3_5.exe file. Follow the steps in the Installation manual Chapter 4 and 5 to configure the device.

Step 10: Connect the power cable of the alarm center to the PWR port. Pay attention to the wire polarity.

Step 11: The device will turn on and start its operation. The PWR LED will continuously light up. Refer to the manual for the status of other LEDs.

Please note that this is a general installation guide. For more detailed instructions and information, refer to the WM Systems M2M Easy 2S Security Communicator Installation Guide provided by the manufacturer.