User Manual Q&AAnswer
Apr 10, 2025 - 03:04 AM
To connect the YESWELDER Foot Pedal to your welding power source or welding generator, follow these steps:
1. If the cord of the foot pedal is equipped with a locking cap, fully insert the cap into the Remote Amperage Control Receptacle on the welding power source or welding generator and rotate clockwise.
2. If the cord of the foot pedal is equipped with a power connector, align the keyway and insert the plug into the receptacle on the welding power source or welding generator. Then, rotate the threaded collar fully clockwise.
Please refer to Table 2-1 in the instruction manual for the appropriate conductor size based on the desired cord length.
Note: It is important to consult the welding power source or welding generator's circuit diagram and/or instruction manual to determine how the foot pedal affects the operation of the equipment.
For more detailed information and safety instructions, please refer to the YESWELDER Foot Pedal Instruction Manual available on the official YESWELDER website at www.YesWelder.com.
Add New Comment