User Manual Q&AAnswer
Apr 10, 2025 - 02:49 AM
Sure! Here are the step-by-step instructions for installing the FABER BACK Series BACKSPLASH Kit:
1. Before installing the hood, make sure to install the backsplash first.
2. Position the lower section of the backsplash on the wall. Center it side to side and mark the mounting holes. Then, remove the lower section from the wall.
3. Attach the lower section of the backsplash to the wall using the 6 screws provided. Make sure to use the Pozi Screws (Screws 3/16" x 1-15/16") for this step.
4. Position the upper section of the backsplash on the wall. The top position of the upper section should be at least 1" above the bottom of the hood, so the recessed screws are covered. Center it side to side and mark the holes. Remove the upper section from the wall.
5. Peel off the double-sided tape on the upper section. Attach the upper section to the wall using the 3 screws provided.
6. Press the upper section to the lower section to ensure that the tape fully adheres to the lower section.
Please note that these instructions are a summary and it is important to refer to the FABER BACK Series BACKSPLASH Kit Instruction Manual for complete and accurate installation details.
Add New Comment