User Manual Q&AAnswer
Apr 10, 2025 - 02:11 AM
To install the SMARTCHOICE 5304512982 6ft 30-Amp 4-Wire Dryer Cord, please follow these steps:
1. Before starting the installation, make sure to turn off the power supply to the outlet to avoid any electrical shock hazard.
2. Locate the xxxx securing the terminal block access cover in the lower corner on the back of the dryer and remove it.
3. Install a UL-approved strain relief according to the power cord/strain relief manufacturer's instructions in the power cord entry hole below the access panel. Make sure the strain relief is loosely in place at this time.
4. Thread an UNPLUGGED, UL-approved, 30 amp power cord (NEMA 14-30 type DRT or SRDT) through the strain relief.
5. Disconnect the internal (WHITE) dryer harness ground wire from the (GREEN) ground xxxx next to the terminal block.
6. Attach the ground (GREEN) power cord wire to the cabinet with the ground (GREEN) xxxx . Tighten the xxxx securely.
7. Move the internal dryer harness ground (WHITE) wire to the terminal block and attach it along with the neutral (WHITE) power cord wire conductor to the center, SILVER colored terminal on the terminal block. Tighten the xxxx securely.
8. Attach the RED and BLACK power cord conductors to the outer, BRASS colored terminals on the terminal block. Tighten both screws securely.
9. It is important not to make a sharp bend or crimp the wiring/conductor at connections to avoid electrical shock hazard. Follow the manufacturer's guidelines for firmly securing the strain relief and power cord.
10. Reinstall the terminal block cover.
Note: If a terminal xxxx falls during cord installation, it can be retrieved in the terminal xxxx recovery slot below the access panel.
Please refer to the SMARTCHOICE 5304512982 6ft 30-Amp 4-Wire Dryer Cord User Manual for additional information and safety precautions.
Add New Comment