User Manual Q&AAnswer
Apr 10, 2025 - 12:57 AM
To mount the SW-MOTECH BC.SYS.07.945.20000B SysBag 30 Bag System on your motorcycle, please follow the instructions provided in the instruction manual. Here is a step-by-step guide on how to mount the bag system:
1. Preparation:
- Read the mounting instructions carefully and ensure that all parts are included.
- Park your vehicle safely and ensure it cannot fall over.
- Turn off the engine and remove the ignition key.
- Let the motor/exhaust cool off if necessary.
- Disconnect the vehicle battery when working on the electrical system.
- Use appropriate tools and have another person to assist you.
2. Mounting:
- Remove the plastic dowels from the license plate holder.
- Attach the mounting tabs to the vehicle using the provided screws. Use liquid thread locker and do not fully tighten the screws yet.
- Attach the mounting brackets to the vehicle using the provided screws. Use liquid thread locker and do not fully tighten the screws yet.
- Attach the crossbar to the license plate holder using the provided screws. Use liquid thread locker and do not fully tighten the screws yet.
- Connect the side carriers to the mounting tabs and crossbar using the fasteners and lock washers. Ensure proper alignment and tighten all screws as specified in the manual.
3. Function Check:
- After installation, ensure that all parts and connections are properly replaced.
- Make sure that no moving parts are obstructed and that the function of the vehicle is not hindered.
- Check that cables and hoses are not rubbing or pinched.
- Perform a comprehensive check of all functions before riding.
- After the first 50 km and at regular intervals, check the tightening torque of all xxxx connections and the proper fit of the product.
Please note that this is a general guide and it is important to refer to the specific instructions provided in the SW-MOTECH BC.SYS.07.945.20000B SysBag 30 Bag System Instruction Manual for your motorcycle model.
Add New Comment