User Manual Q&AAnswer
Apr 10, 2025 - 12:35 AM
To assemble the WISELIFT WLT400 Standing Desk/Overbed Table Tilt, follow these steps:
1. Lay the 3 main parts (table base, column, and top) out on the floor as shown in Figure 1.1.
2. If you intend on using casters, install them in each corner of the base. xxxx them in hand tight and then finish with the provided crescent wrench.
3. Install the column in the desired port (center port if using casters) and cover the unused column ports with the two covers provided (Figure 1.2).
4. Line up the table top and attach it using the provided screws. Use the allen wrench to tighten the screws down (Figure 1.3).
5. Lift the table upright and confirm that all parts are tight and functioning properly.
6. Slide the lift handle into the opening on the side of the column, lining it up with the holes on each side. Insert the bolt through the side of the column, through the handle, and out the other side, and tighten the nut on the other side (Figure 1.4).
7. Move the table to the desired location.
8. Check to see that it’s stable in its final location. If your table is unstable, consider removing the wheels and placing the weight of the furniture on the table base.
9. Once the table has been constructed properly, add the cup holder and USB port into their correct spots.
For more detailed guidance, you can also watch the video tutorial on YouTube by searching "WiseLift Table Assembly".
Please note that if you encounter any problems during the setup and positioning of your lift table, stop and contact a WiseLift representative at 1-877-782-2010 before plugging the unit into the electrical outlet or attempting to fix electrical problems yourself.
Add New Comment