User Manual Q&AAnswer
Apr 09, 2025 - 11:29 PM
To sharpen a drill using the PARKSIDE PSS 65 C1 Tool Sharpening Station, follow these steps:
1. Mount the selected sharpener onto the device according to the instructions in the manual.
2. Remove the drill holder from the sharpener.
3. Insert the drill into the drill holder, making sure not to attach the drill.
4. Insert the drill holder into the adjusting device using the knurled nut for drill-fastening.
5. Push the drill to the front into the V-nut up to the metal stop, ensuring that the cutting edges of the drill fit closely to the metal surfaces.
6. Fasten the drill using the knurled nut for drill-fastening.
7. Remove the drill holder and insert it into the rotatable drill mount from below using the knurled nut for drill-fastening.
8. Check the alignment of the drill, ensuring that the cutting edges of the drill are touching the grinding wheel.
9. Switch on the device and grind the drill by moving the rotatable drill mount back and forth in the direction of the arrow.
10. Switch off the device and wait for the grinding wheel to stop.
11. Remove the drill holder and insert it into the rotatable drill mount by rotating it by 180°. This will allow you to grind the opposite cutting edge of the drill.
12. Switch off the device and grind the drill.
13. Switch off the device and wait for the grinding wheel to stop.
Please refer to the instruction manual for more detailed information and safety precautions.
Add New Comment