User Manual Q&AAnswer
Apr 09, 2025 - 11:52 AM
To connect your speakers to the VONYX VXA Series Two Channel 1500W PA Power Amplifier, follow these steps:
1. Make sure the amplifier is turned off before wiring the system.
2. Speakers can be connected using speaker NL4 plugs or bare wire for the binding post output connectors.
3. Determine the appropriate wire size based on the distance between the amplifier and speakers. Refer to the provided guidelines in the manual for wire size recommendations.
4. Connect the positive (+) output terminals of the amplifier to the corresponding positive terminals on your speakers.
5. If using NL4 plugs, connect the NL4 plugs to the NL4 speaker outputs on the rear panel of the amplifier.
6. If using bare wire, strip the wire insulation and insert the bare wire into the binding post output jacks on the rear panel of the amplifier. Tighten the binding posts to secure the wire.
7. Repeat the above steps for each speaker you want to connect.
8. Once all connections are made, double-check that all connections are secure.
9. Turn on the amplifier and adjust the volume controls as needed.
Note: Never connect a hot (+) output to ground or (-) output, and never connect the hot (+) to other hot outputs.
Add New Comment