User Manual Q&AAnswer
Apr 09, 2025 - 09:46 AM
To install the Lindby 2 Lichts Gips-H: 7 cm-G9-Wit LED Wand Lamp, please follow the instructions provided in the manual. Here is a step-by-step guide:
1. Before starting the installation, carefully unpack the product and check that it is complete and undamaged. Do not use the light if there is any damage to the cable, glass, or electrical parts. Contact the service address mentioned in the manual if there is any damage.
2. Read through the entire instruction manual carefully to familiarize yourself with the installation process and safety precautions.
3. Ensure that you comply with the national installation and safety regulations for the installation, operation, and maintenance of the light. Always follow the symbols and warnings mentioned on the packaging and in the installation instructions.
4. It is recommended to have technical knowledge corresponding to that of a person who has successfully completed training in the electrical trade. If you are not experienced in electrical work, it is advised to have a trained electrician connect the electricity supply.
5. Pay attention to the installation sketch provided on page 9 of the manual. It shows the smallest distance to illuminated areas and provides information on suitable installation surfaces.
6. The lights are not suitable for covering with thermal insulation materials. Additionally, they should not be directly installed on normally flammable surfaces, but only on non-combustible surfaces.
7. Once the light is installed, ensure that it is not exposed to large mechanical loads, stresses, or heavy soiling. Do not change or modify the product as it can cause hazards such as short-circuits, electric shocks, or fires.
8. For cleaning and maintenance, always disconnect the light from the power supply and make sure no voltage is present. Use a dry or lightly moistened cloth for regular cleaning and avoid using chemicals or abrasive cleaners/scouring agents.
9. When disposing of the light, do not throw it in normal household waste. Instead, it should be handed in to a collection point for the recycling of large electrical and electronic appliances. Follow the relevant provisions regarding the separate collection of waste electrical and electronic equipment (WEEE) in your country.
10. The Lindby 2 Lichts Gips-H: 7 cm-G9-Wit LED Wand Lamp is designed, produced, and tested in conformity with EN 60598 and fulfills the fundamental safety requirements of the EU Directives 2014/35/EU and 2014/30/EU. The complete declaration of conformity is available at the service address mentioned in the manual: LUQOM Holding GmbH, Seelbüde 13, D-36110 Schlitz, 020 3514 3658, info@luqom.eu.
If you have any further questions or concerns, please refer to the manual or contact the provided service address for assistance.
Add New Comment