User Manual Q&AAnswer
Apr 09, 2025 - 01:50 AM
To install the Joie i-Juva Enhanced Child Restraint with the base, please follow these steps:
1. Unfold the load leg from the storage compartment.
2. Fit the ISOFIX guides with the ISOFIX anchor points.
3. Rotate the ISOFIX connectors 180 degrees until they are pointing in the direction of the ISOFIX guides.
4. Line up the ISOFIX connectors with the ISOFIX guides and click both ISOFIX connectors into the ISOFIX anchor points.
5. Make sure that both ISOFIX connectors are securely attached to their ISOFIX anchor points. There should be two audible clicks, and the colors of the indicators on both ISOFIX connectors should be completely green.
6. Check to make sure the base is securely installed by pulling on the ISOFIX connectors.
7. After placing the base on the vehicle seat, extend the load leg to the floor. When the load leg indicator shows green, it means it is installed correctly. If it shows red, it means it is installed incorrectly.
8. Make sure the load leg is in full contact with the vehicle floor pan.
9. Squeeze the load leg releasing button, then shorten the load leg upwards.
10. Push the infant carrier module down into the base. If the enhanced child restraint is secure, the enhanced child restraint indicator shows green.
11. Pull up on the infant carrier module to be sure it is securely latched into the base.
12. To release the infant carrier module, pull the infant carrier up while squeezing the infant carrier release button.
13. To remove the base, press the secondary lock button first and then the button on the ISOFIX connectors before removing the base from the vehicle seat.
14. Press the ISOFIX releasing button to fold the ISOFIX.
Please refer to the instruction manual for detailed illustrations and further information on installation.
Add New Comment