User Manual Q&AAnswer
Apr 09, 2025 - 01:00 AM
To install the ORNO Recessed Furniture Sockets, follow these steps:
1. Before starting the installation, ensure that the power source (230 VAC) is disconnected.
2. It is recommended to have a professional electrician carry out the installation works in accordance with local health and safety regulations.
3. Before plugging in the device, make sure that the electric circuit parameters comply with its technical specifications.
4. If the device's wire is damaged, do not use it and have it replaced by a professional electrician.
5. Disconnect the power supply before performing any activities on the product.
6. Do not immerse the device in water or other fluids.
7. Do not operate the device if its housing or wire is damaged.
8. Do not open or repair the device by yourself.
9. Use the device only for its original purpose.
10. The device is suitable for indoor use only.
11. Keep the device out of reach of children.
12. Avoid contact with water and other electric conductors, such as metals.
To install the device:
1. Drill a hole in the surface of a table or desk where you want to install the sockets.
2. Press the button on the outer case to pull out the panel with sockets.
3. Remove the two screws at each side of the panel.
4. Fasten the socket case to the surface of the table or desk using four screws, ensuring that the wires are properly placed.
5. Put the screws back at each side of the panel and tighten them.
6. Close the socket panel.
Please refer to the provided manual for additional technical data and maintenance instructions.
Add New Comment