User Manual Q&AAnswer
Apr 08, 2025 - 11:59 PM
To connect the Sencore MRD 7000 to your network and access the web user interface, you can follow these steps:
1. Using the Pre-Set Management IP Address:
- Connect a PC directly to the eth0 port of the MRD 7000 using an Ethernet cable.
- On your PC, go to Control Panel > Network and Internet > Network and Sharing Center > Network Connection > Properties > Internet Protocol Version 4 Properties.
- Select the "Use the following IP address" option and set the IP address to 10.0.20.60 and the subnet mask to 255.255.0.0.
- Open a web browser on your PC and enter the IP address 10.0.20.101 to access the web user interface of the MRD 7000.
2. Connecting Monitor and Keyboard to the MRD 7000:
- Connect a monitor and keyboard directly to the MRD 7000 server.
- When the MRD 7000 server boots, a console screen will be shown.
- Press the ENTER key on the keyboard to advance to the next menu.
- Configure the network settings by selecting "Configure Networks" and "eth0 Adapter Status" to change the IP settings.
- Once the network ports are configured, press ESC to return to the main menu.
- Verify that the correct IP address is displayed for eth0 or eth1.
- Launch a web browser on your management PC and enter the IP address of the MRD 7000 to access the web user interface.
Note: The default user for login is "admin" and the default password is "mpeg101".
For more detailed information and troubleshooting, please refer to the full User Manual or contact Sencore ProCare support at procare@sencore.com or +1-605-978-4600.
Add New Comment