User Manual Q&AAnswer
Apr 08, 2025 - 10:22 PM
To install the CLEAR DESIGN THREE60 Conference Table, please follow the steps outlined in the provided installation guide. Here is a summary of the installation process:
1. Prepare the surface and measure for legs: Carefully place the surface upside-down on a cushioned area. Measure 12" from the surface edge and center-align to determine leg placement.
2. Secure angled sleigh legs: Follow the measurements and insert screws per leg through the metal plate and into the laminate surface.
3. Measure for cabinet base or covered leg: Place the cabinet base or covered leg centered under the table grommet cutouts.
4. Install cabinet base or covered leg: Insert four screws per base through the laminate top into the bottom of the surface.
5. Attach hardware to surface edge: Insert two wooden dowels, attach two flat brackets, and connect four sets of joint fasteners to one side of each surface edge.
6. Flip and assemble: Flip each piece over so that it is standing on a leg/cabinet base. Align the open holes on the surface edge with the wooden dowels and the threaded rods on the other surface edge.
7. Fully secure hardware.
8. Install grommets: Insert wire management grommets.
For standing height tables, additional steps are involved. Please refer to the specific instructions provided in the manual for standing height installations.
Optional features such as covered sleigh legs and power modules are also available. Detailed instructions for these features can be found in the manual.
If you have any further questions or need additional assistance, please contact Clear Design at 1-866-304-7197 or email inspire@mycleardesign.com.
Add New Comment