How do I install the SILVERSTONE Series High Quality Ball Bearing Sliding Rail Kit? (Silverstone High Quality Ball Bearing Sliding Rail Kit Instruction Manual)

Answer

manuals.plus

Apr 08, 2025 - 12:27 PM

To install the SILVERSTONE RMS07 Series High Quality Ball Bearing Sliding Rail Kit, follow these steps:

Step 1: Take the inner member (smaller slide channel) apart by pulling the front activating release latch forward.

Step 2: Hook the side lip of the cage nut in the square rail hole and lever the cage nut into place.

Step 3: Each slide is pre-attached with front and rear adjustable EIA brackets. Loosen the nuts on both brackets and decide the proper setback distance to the opening. Then, tighten the nuts on the front brackets. Extend the rear brackets to where they reach the rear rack. Do not fully tighten the rear bracket mounting screws until final adjustment is made.

Step 4:
A. Attach the L-shaped bracket to the front mounting flange using an M5*15 xxxx and a 12mm nylon ring from the xxxx kit.
B. Attach the L-shaped bracket to the rear mounting flange using an M5*15 xxxx and a 12mm nylon ring from the xxxx kit. Then, tighten the rear bracket mounting.

Step 5: Attach the inner slide member to your chassis using a xxxx from the xxxx kit.

Step 6: Pick up your chassis and insert it with the inner slide member into the intermediate member. The chassis will be locked when it reaches the fully open position. Then, pull forward on the front activating release latch to push your chassis all the way inward until the closed position.

For more detailed instructions and illustrations, please refer to the SILVERSTONE RMS07 Series High Quality Ball Bearing Sliding Rail Kit Instruction Manual available at www.silverstonetek.com.