User Manual Q&AAnswer
Apr 08, 2025 - 12:21 PM
Sure! Here is a step-by-step guide on how to install the Concept BikeErg Toe Clips One Pair:
1. Gather the necessary tools: You will need a 5/16 inch (8 mm) wrench and a flat head screwdriver. These tools are not included with the product, so make sure you have them on hand.
2. Position the bike: Place your bike in a stable position, either on a bike stand or on the ground with the rear wheel elevated.
3. Locate the pedal: Identify the pedal on which you want to install the toe clips. Each toe clip is specific to the left or right pedal, so make sure you have the correct one for the desired side.
4. Remove the existing pedal reflector (if applicable): If your bike has a reflector attached to the pedal, you may need to remove it before installing the toe clip. Use the flat head screwdriver to carefully pry off the reflector.
5. Align the toe clip: Take the toe clip and align it with the pedal. The curved section of the toe clip should face towards the front of the bike.
6. Insert the screws: Insert the screws provided with the toe clip into the holes on the pedal. Use the 5/16 inch wrench to tighten the screws securely. Make sure the toe clip is firmly attached to the pedal.
7. Repeat for the other pedal: If you want toe clips on both pedals, repeat steps 3 to 6 for the other pedal.
8. Test the installation: Once both toe clips are installed, give them a firm tug to ensure they are securely attached. Make any necessary adjustments or tighten the screws further if needed.
That's it! You have successfully installed the Concept BikeErg Toe Clips One Pair on your bike. Remember to always check the tightness of the screws before each ride to ensure the toe clips remain secure. If you have any further questions or concerns, you can contact Concept2 directly at 800.245.5676 or info@concept2.com.
Add New Comment