How do I connect the BIXOLON SRP-330/332III printer to a network? (BIXOLON Network Connection Instructions)

Answer

manuals.plus

Apr 08, 2025 - 11:17 AM

To connect the BIXOLON SRP-330/332III printer to a network, follow these steps:

1. Turn off the printer to protect it from static electricity.
2. Connect the LAN cable to the printer.
3. Establish a connection with the hub or host using a LAN cable.
4. For LAN configuration, use the "Net configuration tool" provided.
5. After the printer finishes booting, open the printer cover and press and hold the FEED Button for 5 seconds. This will activate the interface setting confirmation mode.
6. Add paper, close the cover, and check if the following message is printed:

0: Exit
1: WLAN Information Print
2: WLAN Factory Reset and Reboot Printer
3 or more: None

7. To select a mode, use the Feed button control as follows:
- Step 1: Short-press as many times as the mode number you want to choose.
- Step 2: Long-press for over 1 second.

For example, to choose Mode 2, press the Feed Button 3 times (short-short-long).

8. If the above message is printed, select Mode 1 to view the WLAN data. Press the Feed button once quickly or once long to select Mode 1.
9. The WLAN data will be displayed, including MAC ADDRESS, IP ADDRESS, SUBNET MASK, GATEWAY, PORT, and INACT. TIME.
10. To change network settings using the Net configuration tool, refer to the "Net configuration tool manual."
11. You can also test the Ethernet connection using the Windows printer driver. Follow the steps provided in the manual for installing and configuring the driver.
12. To perform a factory reset and initialize LAN settings, follow the steps mentioned in the manual.

Please note that these instructions are based on the information provided in the BIXOLON SRP-330/332III Network Connection Instructions manual. For more detailed instructions and troubleshooting information, refer to the manual available on the BIXOLON website (www.bixolon.com).