User Manual Q&AAnswer
Apr 08, 2025 - 09:09 AM
To connect the Holybro 13013 Micro OSD v2 to your FPV system, you will need to follow these steps:
1. Identify the necessary cables: The package includes a GH 6P cable, GH 4P cable, and GH 3P cable.
2. Connect the GH 6P cable: This cable is used to connect the OSD to your flight controller. Locate the 6-pin ISP header on the OSD and connect one end of the GH 6P cable to it. The other end of the cable should be connected to the appropriate port on your flight controller.
3. Connect the GH 4P cable: This cable is used to connect the OSD to your video transmitter (VTx). Connect one end of the GH 4P cable to the BAT+ pin on the OSD. The other end of the cable should be connected to the VTx.
4. Connect the GH 3P cable: This cable is used to connect the OSD to your camera. Connect one end of the GH 3P cable to the BAT+ pin on the OSD. The other end of the cable should be connected to the camera.
5. Optional: If you prefer PAL video, you can use the solder jumper provided on the OSD. This will require soldering the jumper in place.
6. Optional: If you need to access the HSYNC and LOS test points, they are exposed on the OSD for easy connection.
Please note that when connecting the BAT+ pin to your VTx and camera, you should pay attention to the maximum withstand voltage of your equipment to avoid any damage.
For more detailed information and visual guidance, please refer to the Holybro 13013 Micro OSD v2 User Manual.
Add New Comment