User Manual Q&AAnswer
Apr 08, 2025 - 08:36 AM
To install the SHAD K0DT31ST fitting on your Kymco DTX 125-360, please follow these steps:
1. Ensure that you have all the necessary parts included in the kit. Refer to the parts description in the manual to confirm.
2. Before starting the installation, it is important to note that you should not fully tighten the screws until you have confirmed that the kit is correctly attached and aligned.
3. Begin by locating the mounting points on your Kymco DTX 125-360 where the fitting will be attached. These mounting points may vary depending on the specific model of your motorcycle.
4. Position the fitting onto the mounting points, aligning it properly. Ensure that the fitting is securely attached and aligned with the motorcycle's frame.
5. Once the fitting is in place, start tightening the screws. Begin by loosely tightening them to hold the fitting in position.
6. Double-check the alignment and positioning of the fitting. Make any necessary adjustments before fully tightening the screws.
7. After confirming that the fitting is correctly attached and aligned, proceed to fully tighten the screws. Ensure that they are tightened securely but do not overtighten, as this may cause damage.
8. Once the fitting is securely attached, test its stability by gently shaking it. If there is any excessive movement or looseness, recheck the installation and make any necessary adjustments.
9. Finally, refer to the manufacturer's website, www.SHAD.ES, for any additional instructions or information regarding the installation or usage of the SHAD K0DT31ST fitting.
Remember, it is always recommended to consult the product manual or seek professional assistance if you are unsure about any step of the installation process.
Add New Comment