How do I install the GIBRALTAR Galvanized Steel Eave Drip Flashing? (GIBRALTAR Galvanized Steel Eave Drip Flashing Instructions)

Answer

manuals.plus

Apr 08, 2025 - 08:02 AM


Installation of the GIBRALTAR 11448 Galvanized Steel Eave Drip Flashing requires following the provided instructions carefully. Here is a step-by-step guide:

1. Ensure that you are wearing protective eyewear, clothing, and gloves due to the sharp edges of the flashing.

2. Before installation, make sure to store the metal roofing items properly. Do not store them in an open area where moisture can accumulate. Bundle metal products with breathable tarps (not plastic) and store them on a slant for water drainage.

3. Start by positioning the eave drip flashing at the edge of the roof, aligning it with the eave.

4. Secure the flashing to the roof by using appropriate fasteners, such as roofing nails or screws. The specific type and size of fasteners may vary depending on your roofing system, so refer to the manufacturer's recommendations.

5. Install the flashing along the entire length of the eave, ensuring that it is securely attached to the roof.

6. Repeat the installation process for each section of the eave that requires flashing.

7. Once the flashing is installed, inspect it to ensure it is securely fastened and properly aligned.

Please note that the above instructions are a general guide. It is always recommended to refer to the specific installation instructions provided by the manufacturer for the GIBRALTAR 11448 Galvanized Steel Eave Drip Flashing.