User Manual Q&AAnswer
Apr 07, 2025 - 10:53 AM
To assemble the Grainfather SF50 Conical Fermenter, follow these steps:
1. Assembling the Legs:
- Remove the large dome nuts from the body of the fermenter.
- Lay the fermenter gently on its side and mount each of the three legs onto the threaded bolts.
- Secure the dome nuts back into place, ensuring that all the legs are adjusted to the same height.
2. Assembling the Castors (Wheels):
- Push the tab down on each of the castors to lock them in place.
- Lay the fermenter gently on its side and xxxx the castors onto the bottom of the legs.
3. Assembling the Thermowell:
- Remove the nut from the thermowell, leaving the silicone O-ring in place.
- From the inside of the fermenter, feed the thermowell through the thermowell hole on the side of the body.
- Thread the nut back onto the thermowell from the outside of the fermenter and tighten by hand.
4. Assembling the Airlock & Tail Piece:
- Insert the tail of the three-piece airlock into the bung.
- To insert the sample valve tail piece, insert the end with the two o-rings into the sample valve on the inside of the fermenter. Twist the tail piece so that the other end is pointing down.
For visual reference and additional information, you can refer to the Grainfather SF50 Conical Fermenter Instruction Manual or visit their Help Centre at help.grainfather.com.
Add New Comment