User Manual Q&AAnswer
Apr 05, 2025 - 12:04 PM
To connect your effect pedals to the Harley Benton Spaceship Power 60XL, follow these steps:
1. Connect the device to a power source using the supplied power cord.
2. Use a suitable voltage supply cable to connect effect pedals or devices that require 24V supply voltage (up to 2000mA) to Output 1.
3. Use a suitable voltage supply cable to connect devices with high power consumption, such as multi-effect devices, that require 9V supply voltage (up to 3000mA) to Output 2.
4. Use suitable voltage supply cables to connect effect pedals or devices that require 9V supply voltage (up to 250mA) to Outputs 3-6.
5. Use suitable voltage supply cables to connect effect pedals or devices that require 9V supply voltage (up to 500mA) to Outputs 7-9.
6. Use suitable voltage supply cables to connect effect pedals or devices that require 9V, 12V, or 18V supply voltage (up to 500mA, 375mA, or 250mA respectively) to Outputs 10-13. Set the associated switch above the output to the required voltage position.
7. Make sure the polarity of the devices you are connecting matches the polarity of the power supply outputs (+, -).
8. Use suitable voltage supply cables to connect devices like smartphones or tablets to the USB outputs.
9. Each operational output (1-13) is indicated by a green LED. If an output is switched off due to overload, the LED turns off. Disconnect the pedal causing the overload and wait for approximately 2 seconds for the normal voltage supply to be restored.
10. To switch off the device, disconnect the power cord from the mains.
Please refer to the user guide for more detailed information and safety instructions.
Add New Comment