User Manual Q&AAnswer
Apr 05, 2025 - 11:56 AM
To install the XTRELAMP 84758739 AURORA 1 LIGHT LED Table Lamp, please follow the instructions provided in the manual:
1. Before starting the installation, make sure to shut off the power and preferably switch off the electrical panel.
2. Ensure that the lamp is suitable for your intended use. The lamp is designed for domestic use and has an IP20 rating, which means it is suitable for internal use only. If you plan to use it outdoors, make sure it has a higher IP rating.
3. Check the color of the cables before installation. The blue wire is the neutral (N), the brown or black wire is the live (L), and the green/yellow wire is the ground (if the lamp is class II).
4. If the cable is damaged, it should only be replaced by the manufacturer, its service agent, or a qualified person.
5. The lamp is double insulated (protection class II) and does not require grounding. However, if it has a yellow/green wire, it should be connected to the clip marked with the grounding symbol.
6. The connectors provided with the lamp are designed to connect two wires of maximum 1.5mm thickness.
7. Thread the wires through the black hose provided.
8. Connect the wires to the terminal block as shown in the figure: blue wire to the neutral (N) terminal, brown or black wire to the live (L) terminal, and green/yellow wire to the ground terminal (if applicable).
9. Once the wiring is complete, make sure to secure the connections properly.
10. After installation, turn on the power and test the lamp to ensure it is functioning correctly.
Please note that these instructions are a general guide. It is always recommended to consult a qualified professional or refer to the specific instructions provided with the product for accurate installation.
Add New Comment