How do I install and set up the Einhell 41.742.30 Electronic Flow Switch? (Einhell Electronic Flow Switch Instruction Manual)

Answer

manuals.plus

Apr 05, 2025 - 10:44 AM


To install and set up the Einhell 41.742.30 Electronic Flow Switch, please follow these steps:

1. Switch off the pump and unplug its mains plug.
2. Remove the existing output line on the pump.
3.  xxxx  the connection adapter (Item 4) to the output line connector on the pump.
4. Fit the flow switch (Item 1) with the connection thread (Item 5) to the connection adapter and secure it using the union nut (Item 10). Make sure the flow switch is in an upright position, with the connector for the pump at the bottom and the connector for the output line at the top.
5. Raise the non-return valve at the handle (Item 7) and carefully fill the flow switch with the transport fluid up to the bottom end of the thread on the pressure connector (Item 6) to prevent the system from running dry.
6.  xxxx  the output line to the connector provided for it on the flow switch and ensure that the connection is properly sealed, for example, with Teflon tape.
7. Connect the pump's mains plug to the socket (Item 2) on the rear of the flow switch.
8. Connect a consumer to the output line and open it to allow any air in the line to escape.
9. Connect the flow switch's mains lead (Item 3) to a properly fused (at least 10 A) 230 V~ 50Hz safety mains socket with a ground contact.
10. The flow switch is now ready for use. Switch on the pump if it has a switch, or it will start automatically and transport the medium. Close the consumer once the transport fluid is emitted from it.
11. To dismantle, follow the steps in reverse order. If storing the flow switch, ensure it does not contain any transport fluid to avoid frost damage.

Please note that these instructions are a summary and it is important to consult the complete instruction manual for detailed information and safety precautions.