Answer

Apr 05, 2025 - 09:30 AM
To install the LEDALITE Sona Wall LED fixtures, follow these steps:
1. Review the system overview and gather the necessary components, including power mount kits, non-power kits, end kits, and joint kits.
2. Ensure you have the required tools, including a medium Phillips screwdriver, 3/8" wrench or ratchet, and a 1/4" socket or 3/8" GearWrench.
3. Determine the mount spacing and position the wall mount brackets within 6" of the fixture end or joint. Minimum one mount per fixture end and joint.
4. Install the switchbox and make electrical connections. You can either install the switchbox flush with the finished wall directly behind the fixture's specified power location or as close as possible to the power mount location.
5. Attach the switchbox cover plate to the switchbox using the supplied screws. Secure the cover plate to the wall structure with structural screws.
6. Install the wall bracket at the power location. Attach the wall mount bracket to the switchbox cover plate or install it within 6" from the fixture end, close to the power supply. Secure the bracket to the wall structure.
7. Install additional wall mount brackets at non-power locations as required for single fixtures or continuous rows. Ensure these brackets are level with the first bracket.
8. Mount the first fixture by raising it into position and engaging it on the wall brackets. Rotate it down into position.
9. Complete the electrical connection at the end. For power locations, break 1/2" knock-outs in the cross plate before raising the fixture into position. For non-power locations, cap all wires and tuck them into the wire cavity.
10. Mount the second fixture by inserting joiner aligners into it. Raise the fixture into position and engage it on the wall mount bracket at the end opposite the joint. Carefully slide the fixture into position at the joint, ensuring both fixtures are engaged on the joiner aligners.
11. Complete the electrical connections at the joint using the supplied quick-wire connectors. Tuck the wires into the wiring cavity.
12. Secure the joint using the supplied nuts and bolts. Ensure the star washer side faces against the metal plate at the end of the fixture. Repeat this step for each additional fixture in the row.
13. Install the endcaps using the supplied hardware. Two different endcaps are provided for the left and right sides.
14. Secure all components by attaching the fixtures to the wall mount brackets with the supplied screws. Lift the light engine and slide it back into place. Tuck the diffuser back under the front lip of the housing and re-insert the screws holding the light engine in place.
15. Ensure all components are secure and installed according to code.
For more detailed instructions and illustrations, refer to the LEDALITE Sona Wall LED Installation Guide provided by the manufacturer.
Add New Comment