User Manual Q&AAnswer
Apr 05, 2025 - 07:24 AM
To install and set up the Anolis E-Box Remote, follow these steps:
1. Safety Precautions:
- Make sure the available voltage is not higher than stated on the fixture.
- Disconnect the fixture from AC power before removing its cover.
- Check the fixture and cables for any damage.
- Do not install the fixture near an open flame.
- Connect the fixture to a mains socket outlet with a protective earthing connection.
- Do not connect the fixture to a dimmer pack.
- Do not cover the fixture with cloth or other materials.
- The fixture is designed for outdoor use and professional applications only.
- Choose an installation spot that is not exposed to extreme heat or dust.
- Ensure the housing is firmly closed and all screws are tightly fastened.
- Only operate the fixture after familiarizing yourself with its functions.
- Unauthorized modifications on the fixture are forbidden for safety reasons.
- Use the original packaging if the fixture needs to be transported.
2. Mounting:
- Remove the top cover of the E-Box Remote by unscrewing the four fastening screws.
- Fasten the E-Box Remote on a non-flammable flat surface using the four mounting holes in its housing.
- Remove the terminal blocks cover by unscrewing the four fastening screws.
- Pass cables for DMX and Ethernet through the appropriate cable glands and connect them to the terminal blocks.
- Pass cables for Power and LED outputs through the appropriate cable glands and connect them to the terminal blocks.
- Ensure all screws and cable glands are firmly tightened.
- xxxx the terminal blocks cover back onto the E-Box Remote.
- Connect the E-Box Remote to mains power.
- Set the E-Box Remote using the control panel and buttons.
- Disconnect the E-Box Remote from mains power and xxxx the cover back on.
3. Power Connection:
- Connect the L (Line), N (Neutral), and CE (Protective Earth) wires to the appropriate terminals.
- For the US version, connect the Black wire to L, White wire to N, and Green wire to CE.
4. DMX Connection:
- Connect the D+ (Data +), D- (Data -), and 0V (Data ground) wires to the appropriate terminals.
5. Ethernet Connection:
- Connect the TX+ (Transmit +), TX- (Transmit -), RX+ (Receive +), and RX- (Receive -) wires to the appropriate terminals.
6. Eminere Remote Connection:
- Connect the Vcc (Voltage), LED + (LEDs +), D+ (Data +), D- (Data -), 0V (Ground), and Green (Ground) wires to the appropriate terminals.
7. Setting the E-Box Remote:
- Use the control panel and buttons to navigate the menu.
- Set the DMX address, IP address, network mask, and other desired settings.
- Confirm and save the adjusted values.
Please refer to the Anolis E-Box Remote User Manual for more detailed instructions and information.
Add New Comment