User Manual Q&AAnswer
Apr 04, 2025 - 07:05 AM
To turn on the power sequencer, you can either press the Sequence Switch located on the front panel or use the Remote Sequence Control. For remote control, you need to connect the CTRL IN 1 terminal to the GND terminal. Please make sure that the sequence switch on the front panel is off when using remote control.
When the sequence is turned on, the AC line outputs and speaker zones will be powered on in a specific order. The sequence progresses as follows: 1, 2, 3, 4, 5 for AC line outputs, and 1, 2 for speaker zones. When the sequence is turned off, the order is reversed: 2, 1 for speaker zones, and 5, 4, 3, 2, 1 for AC line outputs.
It's important to note that the sequence will only be active when both the Sequence Switch and Remote Sequence Control are turned on.
Add New Comment