How do I properly install the Rizoma Urlo Ride by Wire Grips? (rizoma Urlo Ride Wire Grips User Manual)

Answer

manuals.plus

Apr 04, 2025 - 04:58 AM


To properly install the Rizoma GRDW222Z10 Urlo Ride by Wire Grips, please follow the instructions provided in the user manual. Here is a step-by-step guide:

1. Before you start, make sure to have the installation performed by skilled personnel for your safety.

2. Check the completeness of the kit by referring to the part list in the manual.

3. The difficulty level of the installation is medium, and it should take approximately 15-20 minutes.

4. Start by installing the bushing. Follow the instructions in Step 1 of the manual.

5. Proceed to install the left-hand grip. Step 2 provides detailed instructions on how to do this correctly. Pay attention to the steps mentioned, such as inserting the grip completely, removing it by 20mm, applying a small layer of silicone glue, and then inserting it completely again.

6. Tighten the headless  xxxx  of the left-hand grip using thread locker medium, as instructed in Step 3.

7. Install the right-hand grip, taking care not to damage the throttle cam. Step 4 provides guidance on this.

8. Finally, open the shells of the throttle, insert the right-hand grip, and close the shells. Before riding, open and release the throttle grip at various positions to ensure smooth operation and proper return to the closed position.

Please note that these instructions are a summary of the manual. For complete and accurate installation guidance, it is recommended to refer to the user manual provided with the product.