User Manual Q&AAnswer
Apr 04, 2025 - 02:24 AM
To install the Generation Lighting 88132-12 Herrington One Light Outdoor Wall Lantern, please follow these steps:
1. Before beginning the installation, ensure that the electricity to the system you are working on is turned off. This can be done by either turning off the fuse or setting the circuit breaker to the off position.
2. It is important to only use components from Generation Lighting to avoid voiding the warranty and potential safety hazards.
3. If you are unsure about how to proceed with the installation, it is recommended to contact a qualified electrician for assistance.
4. No special tools are required to install this fixture.
5. Follow the steps in the order guide provided in the instruction manual.
6. Read the instructions carefully and make sure to save them for future reference.
Note: The glass used in this fixture is handcrafted, so slight imperfections may be present, which adds to the authenticity of the product.
Note for fixtures that are solid brass: To maintain the solid brass texture, regularly apply a good quality non-abrasive car wax to all metal surfaces. This will help keep the fixture looking new for years to come.
Before you begin the installation, carefully remove the fixture from the packaging and check that all parts are included as shown in Figure 1. Take care not to misplace any screws or parts needed for installation.
Cleaning: To clean the fixture, wipe it with a soft cloth. Use a mild soap to clean the glass. Avoid using abrasive materials such as scouring pads, powders, steel wool, or abrasive paper.
Ordering parts: Keep the instruction sheet for future reference and in case you need to order replacement parts. Parts for this fixture can be ordered from the place of purchase. When ordering parts, make sure to use the exact wording from the illustration provided in the manual.
Wet location: If the fixture is labeled for wet location and will be used outdoors, it is important to provide a watertight seal between the fixture and the mounting surface. This can be achieved by using silicone or similar caulking.
Please refer to the complete installation instructions provided in the manual for detailed guidance.
Add New Comment