User Manual Q&AAnswer
Apr 04, 2025 - 01:55 AM
To install the Ancerre DESIGNS LEDM-OTTO-24 LED Bathroom Mirror, please follow these steps:
1. Before installation, ensure that the power is turned off. Use a voltage detector to verify this. Also, make sure to turn off the circuit breaker and lock it to prevent anyone from accidentally turning it on.
2. If you are not experienced in installing electrical wiring, it is recommended to hire a professional electrician for your safety.
3. When working with electricity, always avoid water and never touch or install any electrical equipment or circuits with wet hands.
4. Gather the necessary tools for installation, including a voltage tester, wire cutters, wire and cable strippers, needle-nose pliers, continuity tester, and wire closure. Also, wear safety glasses and protective clothing to protect yourself from sparks.
5. Check the wall to ensure that it can support the mirror's weight. Measure the width and height of the mirror back holes/hooks distance using a tape measure.
6. Mark the punching position on the wall with a pencil. Use a level gauge to ensure that the holes are at the same level.
7. Use an impact drill to punch holes in the marked center using a 6-8mm drill bit. The drilling depth should be about SCM. Drive the expansion xxxx into the drilled hole using a hammer.
8. Use a screwdriver to xxxx the xxxx into the expansion xxxx and tighten it. Leave a distance of about 5mm from the wall.
9. Hang the mirror up using the screws.
Please refer to the installation manual provided with the product for more detailed instructions and diagrams.
For any further assistance or inquiries, you can contact Ancerre Designs through their website at www.ancerre.com or reach out to their customer service at 888.830.8828 or via email at info@ancere.com.
Add New Comment