User Manual Q&AAnswer
Apr 04, 2025 - 01:35 AM
To install the Progress Lighting 8727 Alpha Trak Fixture Adapter for chain hung fixtures, please follow the instructions provided in the manual:
1. For use with chain hung fixtures (Figure 1A):
a. Thread the xxxx into the loop and into the cast housing. Tighten the loop firmly, but by hand only.
b. Fasten the chain of the fixture (purchased separately) to the loop and thread the fixture wires up the chain and into the housing.
c. Connect the fixture ground wire to the ground wire from the housing. Connect the white or identified fixture wire (with a ridge, stripe, or groove on the outside surface) to the white supply wire. Connect the plain fixture wire to the black supply wire. Use UL listed wire nuts provided to make connections.
d. Place two body halves over the housing and fasten with two flat head machine screws.
2. For use with chain hung fixtures (Figure 1B):
a. Thread the xxxx into the cast housing and lock it in place with the knurled nut and cap.
b. Slip the cord from the fixture through the xxxx and tighten the strain relief securely to the cord with pliers (not furnished).
c. Connect the ground wire from the fixture to the ground wire in the housing. Connect the white fixture wire to the white wire in the housing. Connect the black fixture wire to the black wire in the housing. Use UL listed wire nuts provided to make connections.
d. Place two body halves over the housing and fasten with two flat head machine screws.
Once the fixture adapter is properly installed, it is ready for mounting to the Progress Trak 1 track.
Please note that it is important to read the instructions carefully and turn off the electricity at the main circuit breaker panel before beginning the installation. If you have any questions or concerns, it is recommended to contact a qualified electrical contractor for assistance.
Add New Comment