User Manual Q&AAnswer
Apr 04, 2025 - 01:08 AM
To install a keystone jack on the TRIPP-LITE N062-048-KJ patch panel, follow these steps:
1. It is recommended to terminate the keystone jacks before installing them.
2. Start by installing keystone jacks in the top row first.
3. On the rear side of the patch panel, hook the terminated keystone jack over the bottom ledge of the blank cutout.
4. Tilt the keystone jack into the port and press firmly on the keystone jack latch.
5. Using a flathead screwdriver or your hands, secure the keystone jack by snapping it into the cutout.
To remove a keystone jack from the patch panel, follow these steps:
1. Using a flathead screwdriver, locate and press the keystone jack latch.
2. Once the latch is pressed, the keystone jack should release from the cutout.
Please note that it is important to refer to the TRIPP-LITE N062-048-KJ user guide for specific instructions and illustrations to ensure proper installation and removal of keystone jacks.
Add New Comment