Answer

Apr 03, 2025 - 05:21 AM
To operate the air jets and blower/heater in the Laurel Mountain PARKER 7 Air Bath, please follow the instructions below:
1. Turn on the blower/heater: The blower/heater is a 10.5 Amp unit that requires a dedicated GFCI circuit. Make sure the bath is properly wired and connected to the power supply. To turn on the blower/heater, simply press the power button located on the control panel.
2. Adjust the blower speed: The air bath features a variable speed blower with automatic purge. To adjust the blower speed, use the speed control buttons on the control panel. You can increase or decrease the speed according to your preference.
3. Activate the air jets: The air bath is equipped with 20 high output lateral air jets. To activate the air jets, press the "Jets" button on the control panel. This will start the air flow and create a soothing massage effect.
4. Select Wave & Pulse modes: The air bath includes Wave and Pulse modes for added relaxation. To activate these modes, use the corresponding buttons on the control panel. The Wave mode creates a gentle wave-like motion, while the Pulse mode provides a pulsating massage.
5. Enjoy Chromatherapy: The air bath also includes Chromatherapy, which uses colored lights to enhance the bathing experience. To activate Chromatherapy, press the "Lights" button on the control panel. You can cycle through different colors or set it to a specific color of your choice.
Please note that for detailed instructions and safety information, refer to the Owner's Manual provided by Laurel Mountain. You can find the manual on their website at www.laurelmountainbath.com under the "Resources" section. If you have any further questions or need assistance, you can contact Laurel Mountain customer service at 800-930-0050.
Add New Comment