Answer

Apr 03, 2025 - 05:13 AM
The installation process for the is as follows:
1. Turn off the power: Before starting the installation, make sure to turn off the power supply to the area where you will be installing the switch.
2. Remove the existing switch: Remove the existing switch from the wall by unscrewing the mounting screws and disconnecting the wires.
3. Connect the wires: Connect the wires from the motion sensor switch to the corresponding wires in the electrical box. The switch should have three wires: a black (hot) wire, a white (neutral) wire, and a green or bare copper (ground) wire. Use wire connectors to secure the connections.
4. Mount the switch: Attach the motion sensor switch to the electrical box using the provided mounting screws. Make sure it is securely fastened.
5. Adjust the settings: The Smart Wave ES34/ES34Z motion sensor switch may have adjustable settings for sensitivity, time delay, and ambient light level. Consult the instruction manual for specific instructions on how to adjust these settings.
6. Restore power: Once the installation is complete, turn the power back on and test the motion sensor switch to ensure it is functioning properly.
Please note that this answer is a general guideline based on the information provided. It is always recommended to refer to the specific instruction manual for accurate and detailed installation instructions for your particular model.
Add New Comment