Answer

Apr 03, 2025 - 04:45 AM
Before applying the Project Source 4767254 1-Pint Plumbing White Anti-slip Coating, it is important to properly prepare the surface. Here are the steps to follow:
1. Tape off the desired area: Use the ¼” vinyl contouring pre-tape to mark off the area where you want to apply the non-slip coating treatment.
2. Sand the surface: Use 220- or 320-grit wet sandpaper to sand the surface until it becomes dull. This step ensures proper adhesion of the coating.
3. Mixing the coating: Shake the base well before mixing. Mix 4 parts base to 1 part hardener. The working time for the mixture is approximately one hour, depending on the temperature.
4. Thinning (if necessary): If thinning is needed, reduce the ratio to 8 parts base to 1 part temperature-rated reducer.
5. Applying the coating: Use an enamel type paint roller to apply a moderate coat(s) of the mixture onto the surface. Continue applying until you achieve the desired coverage consistency and texture.
6. Removing tape and curing: After applying the coating, remove the tape. Allow the coating to cure for 12 to 24 hours.
Please refer to the installation guide provided with the product for more detailed instructions and safety precautions.
Add New Comment