User Manual Q&AAnswer
Apr 03, 2025 - 04:44 AM
Before applying the anti-slip coating, it is important to properly prepare the surface. Here are the steps to follow:
1. Tape off the desired area: Use the provided ¼” Vinyl Contouring Pre-Tape to mark off the area where you want to apply the non-slip coating.
2. Sand the surface: Use 220- or 320-grit wet sandpaper to sand the surface until it becomes dull. This step ensures proper adhesion of the coating.
3. Mixing the coating: Shake the base well before mixing. Mix 4 parts base to 1 part hardener. The working time for the mixture is approximately one hour, depending on the temperature.
4. Thinning (if necessary): If the coating needs to be thinned, reduce the ratio to 8 parts base to 1 part temperature-rated reducer.
5. Applying the coating: Use an enamel type paint roller to apply a moderate coat of the mixed coating onto the surface. Continue applying coats until the desired coverage consistency and texture are achieved.
6. Removing tape and curing: After applying the coating, remove the tape and allow the coating to cure for 12 to 24 hours.
Please refer to the installation guide for more detailed instructions and safety precautions.
Add New Comment