User Manual Q&AAnswer
Apr 03, 2025 - 04:40 AM
To prepare the damaged area before using the Project Source Gel Coat Multi-surface Repair Kit, follow these steps:
1. Remove any grease, wax, debris, or other contaminants from the damaged area.
2. Use acetone to clean up any residual debris. Be careful not to allow the acetone to touch any other areas, so it's recommended to mask off the area around the damaged area.
3. Note that the gel coat or polyester resin does not bind well to epoxy, so do not apply the gel coat over epoxy.
By following these preparation steps, you will ensure a clean and suitable surface for the gel coat repair.
Add New Comment